Oxygen & Gas analyzer:

Online CO Gas Analyser
IR based , Insitu online CO gas analyser for combustion control....
- Local / Remote control unit.
- Data in ppm, mg/m3.
- Insitu, SS316 rugged & reliable probe.
- Works on gas diffusion technique – no choking of filters.
- Fast response.
- No sampling / conditioning of gases.
- Works perfectly even in very dusty application – ideal product to measure CO gas at Air preheater inlet location i.e before ESP.
- Built in online auto zero calibration by plant instrument air.
- Online Manual span verification check facility.
- Single port entry , no misalignment problem , reduced installation requirement.
- Field mounted – No AC panel/room is required, low power consumption.
- Factory pre-commissioned - less work on site.
- Minimal on-site commissioning routines.
- Negligible maintenance.
- No upper limit on duct size.
- Suitable for flue gas temperature above dew point to 400 deg.c.
 

----------------------------------------------------------------------------------------------------------------------------------------------
Opacity/Dust Monitor

Low cost online Opacity/dust emission monitoring.
- High intensity RED LED.
- Non contact.
- No moving parts.
- Auto zero calibration.
- Local control unit.
- Data in %, mg/m3, mg/Nm3.
- Online correction for temperature, pressure, H2O & Oxygen for mg/Nm3.
- Suitable for flue gas path length of 0.5m to 15m.
----------------------------------------------------------------------------------------------------------------------------------------------
Online CO Gas Analyser
Non contact , Open path, field mounted , online IR based CO gas analyser for combustion control.
- Measures across the duct/stack bulk measurement.
- No sampling , conditioning of gases.
- Less power consumption.
- Low maintenance , high availability.
- Built in auto zero calibration.
----------------------------------------------------------------------------------------------------------------------------------------------
Online Oxygen Analyzer
Online Oxygen analyzer using Zirconium oxide technology.
- Special soldering technique for leak tight zirconia sensor.
- No sampling, conditioning of gases.
- Field mounted.
- Highly accurate – Accuracy 0.2% of the measured value.
- Built in pneumatic unit for fully automatic calibration.
- Electronic flow meter to control the ref air & cal air/gas flow.
- Dual range.
- Intuitive operation via soft keys.
- Status display with online help
- Maintenance free.
- Suitable for flue gas temperature above dew point to 760 deg.c , higher temperature up to 1400 deg.c for dust free /clean gas application.

----------------------------------------------------------------------------------------------------------------------------------------------
Coal Mill CO
Exsitu, direct duct mounted online CO gas analyzer.
- Ideal product for the protection of Coal mill..
- No heated sample lines.
- No conditioning of gases.
- IR based.
- Fast response.
- No limit on dust concentration.
- Zero maintenance , high availability.
- Less power consumption.
- Auto zero calibration.

----------------------------------------------------------------------------------------------------------------------------------------------
Insitu Multi Gas Analyser
Insitu IR based Online stack gas emission monitor.
- Capable of measuring upto seven gases like CO,CO2,NO,NO2,SO2,HCL, H2O.
- Built in CO2, H2O , temperature & pressure measurement for online normalization i.e for data in mg/Nm3.
- Data in ppm, mg/m3, mg/Nm3 .
- Insitu, SS316 rugged & reliable probe.
- Works on gas diffusion technique – no choking of filters.
- Fast response.
- No sampling / conditioning of gases.
- Works perfectly even in very dusty application.
- Bulk measurement , can be mounted anywhere after the ESP.
- Built in online auto zero calibration by plant instrument air.
- Online Manual/automatic span verification check facility.
- Single port entry , no misalignment problem , reduced installation requirement.
- Factory pre-commissioned - less work on site.
- Minimal on-site commissioning routines.
- Negligible maintenance.
- No upper limit on duct size.
- Suitable for flue gas temperature above dew point to 400 deg.c.
- MCERT certified.
- Field mounted – No AC panel/room is required, low power consumption.

----------------------------------------------------------------------------------------------------------------------------------------------
Opacity / Dust Monitor
Unique dual beam non contact transmissometer for online Opacity/dust emission monitoring.
- Automatic lens contamination correction for both side optics.
- Automatic zero & span check.
- Dynamic misalignment check.
- Built in fail safe shutter.
- Local & or Remote control unit.
- Data in %, mg/m3, mg/Nm3.
- Online correction for temperature, pressure, H2O & Oxygen for mg/Nm3.
- Low maintenance , high availability.
- High intensity RED LED – no interference of NO2 gas.
- High intensity Green LED – for EPA compliance.
- Suitable for flue gas path length of 0.5m to 12m (higher on request).

----------------------------------------------------------------------------------------------------------------------------------------------
Flue Gas Flow Monitor
Insitu , non contact IR based online stack gas flow monitor.
- Suitable only for hot gas.
- Time correlation techniques.
- No moving parts.
- High reliability.
- Low maintenance.
- Continuous real time measurement.
- Local control unit.
- Data in m/sec, m3/sec.
- Integral auto Low & High Span value check.
----------------------------------------------------------------------------------------------------------------------------------------------
Airpointer
World first out of Box “Plug & Play”.
- Compact, built in AC.
- No separate shelter/rooms are required.
- Wall or mast mounting.
- No floor space needed – hence no buiding permission required.
- Capable of measuring : O3, CO, SO2, H2S, NOx, VOC(BTEX), PM10/2.5, Meteorological data , Indoor air quality.
- Integral Zero air supply for internal sensors calibration.
- Built in Computer (data storage 5 years +).
- Requires 10% of the space (0.7 x 0.3 x 1m).
- Has only 10% of the weight (75kg).
- Requires 10% of the electricity (750 watt).
- Reduces need of on site services through remote service features.
- Lowest operating cost (less consumables).
- Low maintenance (50% over others).
- Remote diagnostic.
- Intrusion alert SMS.
- Email message in case of any problem..
- LAN, WLAN, Internet connectivity (GSM / GPRS).

top


 

 

Copyright ©2011-2019 Stone Pipe Co.